Go to 'Commands' and filter to 'StatusNotifications'. These are charge point notifications that provide information on the connector.

Connector ID 0 = The charge point itself

Connector ID 1 = Connector 1

Connector ID 2 = Connector 2

This status notification is the current status of the charge point. In case of a 'Faulted' status, the charge point will send additional information in the 'Info' tab.

With this info, you can contact the manufacturer to determine what causes the 'Faulted' message and what action you should take. Consult the manufacturer manual if need be.

Did this answer your question?